Engine. Under the hood of the incredible Trans Ams used for the film sat a 400 ci V8 engine, which pushed out somewhere in the realm of 200 horsepower. Torque numbers were a lot higher at around 320 ft/lbs. Unlike many iconic muscle cars that we've all come to know and love, the Trans Am was not that fast.

How fast was the Smokey and the Bandit car?

Pontiac gave modified units of the 1976 Firebird Trans Am Special Edition to the filmmakers. Three out of the four modified units were wrecked by the end of filming. Before she asks the famous question, the camera points to a shot of the speedometer that reads 70mph or 110kph.

How much horsepower does a 6.6 liter Pontiac have?

The 400 cubic inch (6.6 liter) Pontiac V8 was listed as being capable of 220 bhp, however period tests by the National Hot Rod Association showed that it was producing close to 260-280 net horsepower.

How many firebirds were used in Smokey and the Bandit?

Well, Pontiac gave modified examples of the 1976 Firebird Trans Am Special Edition to the 'Smokey and the Bandit' filmmakers. There were four modified 1976 Pontiac Trans Ams provided for the movie. By the time filming ended, three had been wrecked and the last could barely run.

What engine did the Smokey and the Bandit truck have?

“With a big hood and a ton of power beneath said hood, the truck is heaved by a twin-turbo Cummins, with the occasional truck carrying a 3408 Cat instead. The BBC (bumper to back-of-cab) for the W900 model ranges from 121 inches to 130 inches, which makes it one of the largest cabs you can find.”

10 Surprising Facts About The Bandit's '77 Trans Am - Smokey and the Bandit

How much HP did Smokey and the Bandit have?

The Special Edition, known as the “Smokey and the Bandit” edition, came equipped with a 6.6-liter V8 engine known as the Pontiac 400. It produced an estimated 200 horsepower and 325 lb-ft of torque, providing impressive performance for its time.

How much horsepower did the Bandit car have?

Under the hood of the incredible Trans Ams used for the film sat a 400 ci V8 engine, which pushed out somewhere in the realm of 200 horsepower. Torque numbers were a lot higher at around 320 ft/lbs. Unlike many iconic muscle cars that we've all come to know and love, the Trans Am was not that fast.

Did Burt Reynolds do all the driving in Smokey and the Bandit?

Originally Answered: Did Burt Reynolds do all the driving in Smokey and the Bandit? No, most of it was done by Hal Needham. It's a great a piece of trivia.

How many cars were ruined in Smokey and the Bandit?

Pontiac had supplied four new Trans-Ams for the movie, but by the time the final scenes were shot they had wiped out three Trans-Ams and the surviving fourth wouldn't start or run after all of the stunts and crashes, so a push-car was used to push the last remaining Trans-Am into the scene.

Was the Pontiac 400 a good motor?

That made the 400 the top engine in Firebird and GTO for many years as it received a wide range of high-performance cylinder heads and camshafts through various iterations of the Ram Air package. The most powerful version of Pontiac's 400 to ever reach production was the Ram Air IV.

Was the Pontiac 400 a big block?

A Chevrolet Camaro 396 had a big block, but a Pontiac Firebird 400 did not. Buick and Oldsmobile 455s were big blocks, but a Pontiac 455 was not. A Chevrolet 348 was a big block, but a Chevrolet 350 was a small block.

Is Pontiac 428 a good engine?

very good performance but, not race engines. not standard in any Pontiac in 1968. most common of the 428s and they run very well.

How far was the beer run in Smokey and the Bandit?

When Frog asks Bandit if they are really doing 110, the speedometer shows they're going 110km/h, not mph (they're only doing about 67mph). Bandit says that it is 900 miles each way from Atlanta, Georgia to Texarkana, Texas.

How many cop cars were used in Smokey and the Bandit?

He contacted Pontiac and an agreement was made that four 1977 Trans Ams and two Pontiac LeMans four-door sedans would be provided for the movie.

What was the last Smokey and the Bandit car?

According to Barrett-Jackson, the 1977 Pontiac Firebird Trans Am SE being auctioned at its April 18-20 Palm Beach event was the last one personally owned by Burt Reynolds. As the story goes, Smokey and the Bandit was such a runaway hit that General Motors promised Reynolds a new car every year for life.

Who owns the original Smokey and the Bandit car?

Gene Kennedy owns the original Smokey and the Bandit car. He owns Bandit Movie Cars and is a longtime friend of Burt Reynolds, who starred in the iconic movie.

Where was Smokey and the Bandit filmed?

Smokey and the Bandit Locations

The movie locations, from Lakewood Fairgrounds in Atlanta to Main and Mill Street in Jonesboro, were full of small-town charm and a rural feel. In McDonough's Town Square, iconic car chase scenes were filmed.

What did Sally Field say about Burt Reynolds?

In a 2022 interview with Variety, Field said Reynolds had reimagined in his 2015 memoir “But Enough About Me” that she was the love of his life. “He had somehow invented in his rethinking of everything that I was more important to him than he had thought, but I wasn't,” she said.

Who owned Fred the dog in Smokey and the Bandit?

The dog's name in "Smokey and the Bandit" was Fred, a basset hound that belonged to Jerry Reed's character, Cledus "Snowman" Snow.

Why did Burt Reynolds leave Smokey and the Bandit 3?

Original "Smokey and the Bandit" director Hal Needham and its big star Burt Reynolds were not interested in making this movie as they were developing another project, Stroker Ace (1983). Reynolds ended up making a very brief cameo appearance though, in the final scene.

Who drove the car in Smokey and the Bandit?

The film, directed by Hal Needham, starred Burt Reynolds as Bo “Bandit” Darville, a charismatic and daring driver tasked with transporting a truckload of Coors beer from Texas to Georgia within a tight deadline.

What truck did Bandit drive?

According to Wikipedia, Bandit drives a 1973 or 74 Kenworth W900 in the Movie.